One of the problems with stock cabinetry is the fact that the finish is already applied to the cabinet and associated “loose” trim. This means that any fastener holes will need to be filled and somehow finished so they blend in with the factory finish. Anyone that’s tried this knows it’s a tall task and the results can be less than satisfying.
Instead of dragging out the air hose and risking a split in your decorative trim or an ugly nail hole I recommend you use glue where ever possible. The vanity cabinet pictured to the right has a perfect example with a very small trim piece that covers the seam between the upper and lower cabinets that were stacked.
Once the glue has setup I simply remove the tape and you’re finished. No nail holes to fill, no headless pins sticking out, no split trim. This technique works on thin filler panels (assuming you can clamp them in place while the glue dries), crown molding, band molding and any type of decorative cabinet trim that’s not “structural” in the sense of holding the cabinet boxes together.
Which is Better a Stick Nailer or Coil Nailer? Framers have many choices in nailers…
Estimating How Many Nails for a New Roof When it comes to estimating materials for…
Composite / PVC Decking Layout Tips and Advice Composite and PVC decking have really changed…
Benefits of ERV Systems (Energy Recovery Ventilator) If you're building a new home or doing…
Vermiculite Attic Insulation If your home was built before 1990 there is a chance it…
Arc Fault (AFCI) Circuit Breakers Tripping Often An arc-fault circuit interrupter (AFCI) or arc-fault detection…
View Comments
Where i can buy a glue for wood ?